Toshiba MiNi-SMMS MCY-MAP0501HT Service Manual page 180

No. Part name
8 Attachment/
detachment of
pipe fixing
rubber
<Disassembling>
1) Squeeze the band either side of the clip to
2) Pushing in the tab side of SUS band the tab
<Assembly>
1) Individually fit each rubber bracket to the
2) For assembly align the tab side of the SUS
3) Attach the rubber band so that there is no
4) Squeeze the rubber bracket and band so
Procedure
REQUIREMENT
Wear protective clothing on your hands as
other components may cause injury etc.
release.
comes off from square hole.
relevant pipe.
band to the slit side of the rubber bracket.
gap between the SUS band and the fixing
rubber bracket. Pay special attention no to
create a gap at the hair pin of the rubber
band.
that the hook part of the band clips into the
square hole.
1)
Compress the rubber to release the cup.
1)
Push in the band towards the arrow mark.
Align the direction of the slits
and then attach to each pipe.
1)
Align the tabs to the slit side of the rubber.
2)
3)
Slide the square hole side
towards the arrow mark.
4)
Push the tab side up against the rubber.
180
Remarks
1)
Matching the tabs, slide them.
Slide it.
Push the band against the
rubber to eliminate any gaps.