Replacing A Memory Module - Lenovo ThinkCentre 8290 Hardware Maintenance Manual

4. There are three plastic tabs on each side of the bezel. While applying pressure
5. When the tabs are all released, remove the bezel from the chassis.
6. Route the power switch/LED cable through the hole in the chassis and to the
7. Align the tabs in the chassis and snap it into position. Install the two screws on
8. Reconnect the power switch/LED cable to the system board.

Replacing a memory module

1. Remove the left-side cover. See "Removing the covers" on page 86.
2. Locate the memory connectors. See or "Identifying parts on the system board
3. Open the retaining clips and remove the failing memory module.
on the top of the bezel, release each tab starting with the tabs at the top.
Note: The power switch/LED assembly cable is connected inside the bezel. Be
careful to not damage the cable and connectors when removing the bezel
from the chassis.
To replace the bezel:
system board.
each side to secure the bezel.
(Types 8290, 8291, and 8292" on page 89 or "Identifying parts on the system
board (Types 9214, 9215, and 9216" on page 90.
Chapter 8. Replacing FRUs (Types 8290, 8291, 8292, 9214, 9215, and 9216
91