Identifying Parts On The System Board; And 9216; Removing And Replacing The Front Bezel - Lenovo ThinkCentre 8290 Hardware Maintenance Manual

Identifying parts on the system board (Types 9214, 9215, and 9216

Removing and replacing the front bezel

The front bezel must be removed to replace some FRUs.
1. Remove both the left-side and right-side covers. See "Removing the covers" on
2. Disconnect the cable for the power switch/LED assembly from the system
3. Remove the four screws that secure the bezel. There are two on each side
90
Hardware Maintenance Manual
1 Microprocessor and heat sink
2 Microprocessor fan connector
3 Memory connector 1
4 Memory connector 2
5 Power connector
6 Diskette drive connector
7 Primary IDE connector
8 Secondary IDE connector
9 Fan connector
page 86.
board. See "Identifying parts on the system board (Types 8290, 8291, and 8292"
on page 89 or "Identifying parts on the system board (Types 9214, 9215, and
9216"for the connector location.
located as shown.
10 Front panel connector
11 Power switch/LED connector
12 Clear CMOS/Recovery jumper
13 Front USB connector
14 CMOS battery
15 PCI connectors
16 Front audio connector
17 AGP connector
18 12V power connector