Replacing an optical drive
1. Remove the cover. See "Removing the covers" on page 86.
2. Remove the drive bay assembly. See "Removing and replacing the drive bay
3. Remove the screws that secure the drive in the drive bay assembly.
4. Slide the drive being replaced out the front of the drive bay assembly.
5. Slide the new drive into the bay until the screws holes on each side are aligned
6. Reinstall the drive bay assembly. See "Removing and replacing the drive bay
7. Go to "Completing the FRU replacement." on page 135.
132
Hardware Maintenance Manual
assembly" on page 116.
and install the screws that secure the drive to the drive bay assembly.
assembly" on page 116.