Selecting A Startup Device; Selecting A Temporary Startup Device; Changing The Startup Device Sequence; Exiting From The Cmos Setup Utility Program - Lenovo ThinkCentre 8290 Hardware Maintenance Manual

1. From the CMOS Setup Utility program menu, select Set Administrator
2. Press any key to continue.

Selecting a startup device

If your computer does not start up (boot) from a device such as the CD-ROM,
diskette, or hard disk as expected, use one of the following procedures to select a
startup device.

Selecting a temporary startup device

Use this procedure to startup from any boot device.
Note: Not all CDs, hard disks, and diskettes are startable (bootable).
1. Turn off your computer.
2. Press and hold the F12 key then turn on the computer. When the Startup
3. Select the desired startup device from the Startup Device Menu and press Enter
Note: Selecting a startup device from the Startup Device (Boot) menu does not

Changing the startup device sequence

To view or change the primary or automatic power-on startup sequence, do the
following:
1. Start the CMOS Setup Utility program (see "Starting the CMOS Setup Utility
2. Select Advanced BIOS features.
3. Select the sequence of devices for the First Boot Device, the Second Boot
4. Press Esc to return to the CMOS Setup Utility program menu.
5. Select Save & Exit Setup.
If you have changed these settings and want to return to the default settings, press
(N) when the Save and Exit dialog box is displayed.

Exiting from the CMOS Setup Utility program

When you finish viewing or changing settings, press Esc to return to the CMOS
Setup Utility program menu (you might have to press Esc several times). If you
want to save the new settings, select Save & Exit Setup before you exit. Otherwise,
your changes will not be saved.
Password and press Enter. A message will display that indicates the password
has been disabled.
Device Menu (Boot Menu) appears, release the F12 key.
Note: If you are using a USB keyboard and the Startup Device Menu does not
display using this method, repeatedly press and release the F12 key
rather than leaving it pressed when turning on the computer.
to begin.
permanently change the startup sequence.
program" on page 51).
Device, and the Third Boot Device.
Chapter 6. Using the CMOS Setup Utility
53