Lenovo ThinkCentre 8290 Hardware Maintenance Manual page 64

58
Hardware Maintenance Manual
Diagnostic Error Code
000-196-XXX
BIOS test halt, error threshold exceeded
000-197-XXX
BIOS test warning
000-198-XXX
BIOS test aborted
000-199-XXX
BIOS test failed, cause unknown
000-250-XXX
BIOS APM failure
000-270-XXX
BIOS ACPI failure
001-000-XXX
System Test Passed
001-00X-XXX
System Error
001-01X-XXX
System Error
001-024-XXX
System Addressing test failure
001-025-XXX
System Checksum Value error
001-026-XXX
System FLASH data error
001-027-XXX
System Configuration/Setup error
FRU/Action
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, "Using the CMOS Setup
Utility," on page 51
2. Re-run test
3. Replace the component that is called out
in warning statement
4. Replace the component under test
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, "Using the CMOS Setup
Utility," on page 51
2. Flash the system and retest. See "Flash
update procedures" on page 184
3. Go to "Undetermined problems" on page
82
1. Go to "Undetermined problems" on page
82
2. Flash the system and re-test
3. Replace component under function test
1. Flash the system. See "Flash update
procedures" on page 184
2. System board
1. Flash the system. See "Flash update
procedures" on page 184
2. System board
No action
System board
System board
System board
1. Flash the system. See "Flash update
procedures" on page 184
2. System board
1. Flash the system. See "Flash update
procedures" on page 184
2. System board
1. Run Setup
2. Flash the system. See "Flash update
procedures" on page 184
3. System board