Installation; Receiver - Worcester 24CDi Instruction Manual

Printed Circuit Board (PCB)
ST5 Receiver connection
OPERATING & INSTALLATION
10
INSTRUCTIONS
DANGER: 230 VOLTS
DO NOT TOUCH THE
ELECTRICAL COMPONENTS
OR CIRCUITS
CAUTION:
ISOLATE THE MAINS ELECTRICITY
SUPPLY BEFORE STARTING ANY
WORK AND OBSERVE ALL RELEVANT
SAFETY PRECAUTIONS
OBSERVE ELECTRO-STATIC
DISCHARGE PRECAUTIONS.
DO NOT TOUCH THE PCB CIRCUIT
NOTE: THIS ACCESSORY MUST BE FITTED
BY A COMPETENT PERSON.
FAILURE TO COMPLY COULD LEAD
TO PROSECUTION.
1. Remove the blanking plate from the fascia by
gently pulling the plate towards you to release
the tabs.
2. Present the receiver up to the fascia, plug the
connecter onto the PCB as shown in the figure
below. Ensure the connector is pushed firmly
home.
3. Introduce the receiver tabs into the slots in the
fascia.
Ensure that the lead is not trapped and then
push the receiver into place to secure.
DIGISTAT PROGRAMMABLE 24 HOUR
ROOM THERMOSTAT SYSTEM
8 716 114 518a (09.07)

RECEIVER

INSTALLATION