Receiver; Operational Controls - Worcester 24CDi Instruction Manual

Large or Small Receiver
The Receiver provides the link with the room
Programmer /Thermostat.
The Receiver indicates when heat is demanded with
a green light and confirms the RF link with a flashing
red light.
Transmitter signal light
red LED.
The red LED will flash
for approximately 7 sec-
ond every 5 minutes.
This confirms the RF
signal is being received.
OVERRIDE button.
The heating can be
manually switched
ON or OFF
OVERRIDE button.
The heating can be
manually switched
ON or OFF
SIGNAL
OVERRIDE
DIGISTAT PROGRAMMABLE 24 HOUR
ROOM THERMOSTAT SYSTEM
8 716 114 518a (09.07)
The heating can be switched ON or OFF at this unit,
overriding the room Programmer.
Pressing OVERRIDE will change the state of the
appliance, turning it OFF if it is ON or ON is it is
OFF.
HEATING ON
SIGNAL
OVERRIDE
2
LEARN
MODE
1
Small Receiver for:
24i Junior, 28i Junior
and Si Mk II
HEATING ON
2 1
LEARN
MODE
OPERATING & INSTALLATION
INSTRUCTIONS

RECEIVER

OPERATING CONTROLS
Large Receiver for:
24CDi, 26CDi Xtra, 28CDi,
35CDi Mk I and 35CDi Mk II
Heating demand light
green LED
The green LED will
be ON when there is
demand for heat.
Learn mode buttons.
Pressing these buttons
together will cause the
receiver to establish an
RF link with the trans-
mitter.
9