General Operation - Gree R410A Service Manual

Super Free Match
Service Manual
13) T-ON/ T-OFF:
Press T-ON button to initiate the auto-ON timer. To cancel the auto-timer program, simply press this button
again.
After press of this button,
5 seconds, press + or - button to adjust the time value. Every press of either button changes the time setting by 1
minute. Holding down either button rapidly changes the time setting by 1 minute and then 10 minutes. Within 5
Seconds after setting, press TIMER ON button to confirm.
Press T-OFF button to initiate the auto-off timer. To cancel the auto-timer program, simply press the button
again. TIMER OFF setting is the same as TIMER ON.
14) TURBO:
Press this button to activate / deactivate the Turbo function which enables the unit to reach the preset
temperature in the shortest time. In COOL mode, the unit will blow strong cooling air at super high fan speed. In
HEAT mode, the unit will blow strong heating air at super high fan speed.
15) LIGHT:
Press LIGHT button to turn on the display's light and press this button again to turn off the display's light. If
the light is turned on,
16) X-FAN:
Pressing X-FAN button in COOL or DRY mode, the icon
operation for 10 minutes in order to dry the indoor unit even though you have turned off the unit. After
energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
3.3.2 Guide for General Operation
1) Combination of "＋"and "－" buttons: About lock
Press "＋" and "－" buttons simultaneously to lock or unlock the keypad. If the remote controller is locked,
is displayed. In this case, pressing any button,
2) Combination of "MODE " and "－" buttons :
About switch between Fahrenheit and centigrade At unit OFF, press "MODE" and "－" buttons
simultaneously to switch between
3) Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function. Nixie tube on
the remote controller displays "SE". Repeat the operation to quit the function.
4) Combination of "TEMP " and "CLOCK" buttons: About 8℃ Heating Function
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start 8℃ Heating Function Nixie tube on
the remote controller displays "
the operation to quit the function.
5) About Back-lighting Function
The unit lights for 4s when energizing for the first time, and 3s for later press.
CONTROL 46
disappears and "ON "blinks. 00:00 is displayed for ON time setting. Within
is displayed. If the light is turned off,
and .
℃ ℉
" and a selected temperature of "8℃". (46℉ if Fahrenheit is adopted). Repeat
disappears.
is displayed and the indoor fan will continue
blinks three times.