Enable/Disable Application Layer Gateways (Alg) - TRENDnet TEW-818DRU User Manual

TRENDnet User's Guide
4. Click on Enabled under Gaming Function section.
5. Review the virtual server settings. Click Apply to save settings.
• LAN IP Address: Enter the IP address of the device to forward the port (e.g.
192.168.10.101).
• TCP Ports to Open: Enter the TCP port you would like to set.
• UDP Ports to Open: Enter the UDP port you would like to set.
Note: Please refer to the device documentation to determine which ports and
protocols are required. You should assign a static IP address to the device or use
DHCP reservation to ensure the IP address of the device does not change.
• Schedule: Select the defined schedule you would like to have the rule to be applied
(see "Create Schedule" section on page 33).
• Enabled: Selecting Enabled turns on the virtual server and selecting unchecking
disables the rule.
© Copyright 2014 TRENDnet. All Rights Reserved.

Enable/disable Application Layer Gateways (ALG)

Advanced > Firewall > ALG
You may want to configure your router to allow computers the use of specific high layer
applications or service sessions to pass through. Application Layer Gateways (ALG)
allows you to easily enable or disable these applications to pass through your router.
Note: It is recommended to leave these settings enabled.
1. Log into your router management page (see
on page 17).
2. Click on the Advanced tab.
3. Click on the Firewall section and click on Special Applications.
4. Review the applications to enable or disable. Click Apply to save the changes.
• Email Receiving (POP3): Allows POP3 protocol through your router.
TEW-818DRU
"Access your router management page"
38