Delete Address_Binding; Enable Address_Binding Trap_Log - D-Link xStack DGS-3400 Cli Manual

xStack

delete address_binding

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an IP–MAC-Port Binding entry on the Switch:
D G S –3 4 26 :5 # d el e te a d d re s s– bi n d in g i p– m a c i pa dd r e ss 10 .1 . 1 .1 ma c_ a d dr e ss 0 0 – 00 –
0 0 – 00 – 00 –0 6
C o m ma n d: d e l et e a dd r e ss – bi nd i n g i p– ma c ip a dd re s s 1 0 .1 .1 . 1 m a c_ ad d r es s 0 0– 0 0 –0 0 –
0 0 – 00 – 06
S u c ce s s.
D G S –3 4 26 :5 #

enable address_binding trap_log

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the sending of IP–MAC-Port Binding trap/log messages on the Switch:
D G S –3 4 26 :5 # e na b le a d d re s s_ bi n d in g t ra p _ lo g
C o m ma n d: e n a bl e a dd r e ss _ bi nd i n g t ra p_ l o g
S u c ce s s.
D G S –3 4 26 :5 #
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to delete IP–MAC-Port Binding entries.
delete address_binding [ip_mac [ipaddress <ipaddr> {mac_address <macaddr>} |
all] | blocked [all | vlan_name <vlan_name> mac_address <macaddr>]]
This command is used to delete IP–MAC-Port Binding entries. Two different kinds of
information can be deleted.
•
ip_mac – Individual Address Binding entries can be deleted by entering the MAC
and IP addresses of the device. Toggling to all will delete all the Address Binding
entries.
•
blocked – Blocked address binding entries (bindings between VLAN names and
MAC addresses) can be deleted by entering the VLAN name and the MAC
address of the device. To delete all the Blocked Address Binding entries, toggle
all.
<ipaddr> – The IP address of the device where the IP–MAC-Port Binding is made.
<macaddr> – The MAC address of the device where the IP–MAC-Port Binding is made.
<vlan_name> – The VLAN name of the VLAN that is bound to a MAC address in order to
block a specific device on a known VLAN.
all – For IP-MAC-Port Binding all specifies all the IP–MAC-Port Binding entries; for
Blocked Address Binding entries all specifies all the blocked VLANs and their bound
physical addresses.
Only Administrator and Operator-level users can issue this command.
Used to enable the trap/log for the IP–MAC-Port Binding function.
enable address_binding trap_log
This command, along with the disable address_binding trap_log, will enable and
disable the sending of trap/log messages for IMPB. When enabled, the Switch will send a
trap/log message when an ARP packet is received that doesn't match the IMPB white list.
None.
Only Administrator and Operator-level users can issue this command.
145