Link Aggregation Commands; Create Link_Aggregation; To Create A Link Aggregation Group - D-Link xStack DGS-3400 Cli Manual

xStack
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create link_aggregation group_id
delete link_aggregation group_id
config link_aggregation group_id
config link_aggregation algorithm
show link_aggregation
config lacp_port
show lacp_port
Each command is listed, in detail, in the following sections.

create link_aggregation

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To create a link aggregation group:

D G S –3 4 26 :5 # c re a te l i n k_ a gg re g a ti o n gr o u p_ i d 1
C o m ma n d: c r e at e l in k _ ag g re ga t i on gr ou p _ id 1
S u c ce s s.
D G S –3 4 26 :5 #
NOTE: When using LACP or static type link aggregation, be sure that both sides of
the connection are identical in speed and duplex settings.
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Parameters
<value 1–32> {type [lacp | static]}
<value 1–32>
<value1–32> {master_port <port> | ports <portlist> state [enable | disable]}
(1)
[mac_source | mac_destination | mac_source_dest | ip_source |
ip_destination | ip_source_dest]
{group_id <value 1–32> | algorithm}
<portlist> mode [active | passive]
{<portlist>}
Used to create a link aggregation group on the Switch.
create link_aggregation group_id <value 1–32> {type [lacp | static]}
This command is used to create a link aggregation group with a unique identifier.
<value> − Specifies the group ID. The Switch allows up to 32 link aggregation groups to
be configured. The group number identifies each of the groups.
type – Specify the type of link aggregation used for the group. If the type is not specified
the default type is static.
•
lacp – This designates the port group as LACP compliant. LACP allows
dynamic adjustment to the aggregated port group. LACP compliant ports may
be further configured (see config lacp_ports). LACP compliant must be
connected to LACP compliant devices.
•
static – This designates the aggregated port group as static. Static port groups
cannot be changed as easily as LACP compliant port groups since both linked
devices must be manually configured if the configuration of the trunked group is
changed. If static link aggregation is used, be sure that both ends of the
connection are properly configured and that all ports have the same
speed/duplex settings.
Only Administrator and Operator-level users can issue this command.
L A
INK GGREGATION
134
18
C
OMMANDS