D-Link xStack DGS-3400 Cli Manual page 82

xStack
config syslog host all
Restrictions
Example usage:
To configure all syslog hosts:
D G S –3 4 26 :5 # c on f ig s y s lo g h os t al l s ev e r it y a ll
C o m ma n d: c o n fi g s ys l o g h os t a l l s ev er i t y a ll
S u c ce s s.
D G S –3 4 26 :5 # c on f ig s y s lo g h os t al l f ac i l it y l oc a l 0
C o m ma n d: c o n fi g s ys l o g h os t a l l f ac il i t y l oc al 0
S u c ce s s.
D G S –3 4 26 :5 # c on f ig s y s lo g h os t al l
C o m ma n d: c o n fi g s ys l o g h os t a l l
S u c ce s s.
D G S –3 4 26 :5 # c on f ig s y s lo g h os t al l i pa d d re s s 10 . 4 4. 6 7. 8
C o m ma n d: c o n fi g s ys l o g h os t a l l i pa dd r e ss 10 .4 4 . 67 . 8
S u c ce s s.
D G S –3 4 26 :5 # c on f ig s y s lo g h os t al l s ta t e e n ab le d
C o m ma n d: c o n fi g s ys l o g h os t a l l s ta te e na b le d
S u c ce s s.
D G S –3 4 26 :5 #
delete syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a previously configured Syslog host:
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
local6 − Specifies that local use 6 messages will be sent to the remote host. This
corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages will be sent to the remote host. This
corresponds to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that the syslog protocol
will use to send messages to the remote host.
state [enable | disable] − Allows the sending of syslog messages to the remote host,
specified above, to be enabled and disabled.
Only Administrator and Operator-level users can issue this command.
ud p_ p o rt
Used to remove a syslog host, that has been previously configured, from the Switch.
delete syslog host [<index 1–4> | all]
This command is used to remove a syslog host that has been previously configured from
the Switch.
<index 1–4> − Specifies that the command will be applied to an index of hosts. There are
four available indexes, numbered 1 through 4.
all − Specifies that the command will be applied to all hosts.
Only Administrator and Operator-level users can issue this command.
ud p _ po r t 6 0 0 0
6 00 0
78