Config Radius; Show Radius - D-Link xStack DGS-3400 Cli Manual

xStack
D G S –3 4 26 :5 # c on f ig r a d iu s d el e t e 1
C o m ma n d: c o n fi g r ad i u s d el et e 1
S u c ce s s.
D G S –3 4 26 :5 #

config radius

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the RADIUS settings:
D G S –3 4 26 :5 # c on f ig r a d iu s 1 a u t h_ p or t 6 0 r e tr an s m it 1
C o m ma n d: c o n fi g r ad i u s 1 a ut h _ po r t 60 r et r an sm i t 1
S u c ce s s.
D G S –3 4 26 :5 #

show radius

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to configure the Switch's RADIUS settings.
config radius <server_index 1-3> {ipaddress <server_ip> |key <passwd 32> |
auth_port <udp_port_number 1-65535 > | acct_port <udp_port_number 1-65535
>|timeout <int 1-255> |retransmit <int 1-20>}(1)
This command is used to configure the Switch's RADIUS settings.
<server_index 1–3> − Assigns a number to the current set of RADIUS server settings. Up
to three groups of RADIUS server settings can be entered on the Switch.
ipaddress <server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between the Switch and
the RADIUS server.
• <passwd 32> − The shared–secret key used by the RADIUS server and the
Switch. Up to 32 characters can be used.
auth_port <udp_port_number 1–65535> − The UDP port number for authentication
requests. The default is 1812.
acct_port <udp_port_number 1–65535> − The UDP port number for accounting requests.
The default is 1813.
timeout <int 1-255> – The time in seconds, that will wait for a reply from the server. If the
corresponding global parameter is supported, by default, the value will follow the global
settings. Otherwise, the default value is 5 seconds.
retransmit <int 1-20> – The count for re-transmit. If the corresponding global parameter is
supported, by default, the value will follow the global settings. Otherwise, the default
value is 2.
Only Administrator and Operator-level users can issue this command.
Used to display the current RADIUS configurations on the Switch.
show radius
This command is used to display the current RADIUS configurations on the Switch.
None.
None.
196