Assembly - Weslo pursuit CT 3.8 R User Manual

ASSEMBLY

To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
wrench , and pliers
As you assemble the exercise cycle, use the drawings below to identify the small parts used in assembly. The
number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of
this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small
parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been pre-
assembled.
M4 Washer M6 Washer
(70)–2
(68)–8
M8 Locknut
M6 Locknut
(63)–4
M6 x 30mm Button
Bolt (64)–4
M8 x 20mm Button
Screw (34)–3
M10 x 60mm Button Screw (33)–2
.
M6 Curved
Washer (69)–4
M10 Locknut
(10)–4
(65)–2
M6 x 35mm Button
Screw (61)–8
M8 Split M8 Washer
Washer (42)–3 (54)–4
M4 x 5mm
Self-tapping
Screw (66)–2
M8 x 65mm Button Bolt (72)–2
M8 x 125mm Bolt (62)–2
M10 x 75mm Carriage Bolt (30)–2
5
, an adjustable
M8 Curved
Washer (46)–2
M4 x 8mm
M4 x 15mm
Screw (29)–2
Self-tapping
Screw (47)–4