Table of Contents
Advertisement
Operating Your Camera
Notes
• When the power frequency is 50Hz, you can not use line-lock mode(NTSC Models).
• When the power frequency is 60Hz, you can not use the line-lock mode(PAL Models).
• 'Sync.' mode is fixed to 'INT' in DC 12V input power.
PRIVACY: To mask area which you want to mask
- OFF: Deactivation
- ON: Privacy mode activated
· Press the SET button.
· Move the arrow indicator to area you want to mask.
· Set 'ON' using LEFT or RIGHT button.
· Press the SET button and then set the area's bounds with the method like
MD1 Set. (see page 24)
· When completed, press the SET button.
RESET: To reset your camera to factory default condition
END: To move Top-menu
EXIT: To finish setting menu
32
COLOR CCD CAMERA
User's Manual
Using Remote Jack / MD Output
If you connect a remote plug to the REMOTE jack on the rear of the camera
as shown below, you can access the menu setup mode from a remote place.
1. RS-232C Communication Setting.
• Mode : Serial
• Data Bit : 8
• Port : Com1
• Parity : None
2. Setup menu Command.
Setup menu
Command
Set
AA, EE, 0F, CC, 55
Up
AA, EE, 1E, CC, 55
Down
AA, EE, 1D, CC, 55
Left
AA, EE, 1B, CC, 55
Right
AA, EE, 17, CC, 55
3. MD(MOTION DETECTION) output Signal Level (Less than 10mA)
0V
There is no motion
2.5±0.5sec
Notes
• You must turn the camera power off when you connect or remove the remote plug.
COLOR CCD CAMERA
• Bit/sec : 19200bps
• Stop Bit : 1
Byte
5
5
5
5
5
+4.0V~+5.0V
There is motion
33
User's Manual
Advertisement
Table of Contents
