Using Reomte Jack / Md Output; Troubleshooting - Samsung SHC-721AH Instruction Manual

Using Remote Jack / MD Output
If you connect a remote plug to the REMOTE jack on the rear of the camera
as shown below, you can access the menu setup mode from a remote place.
1. RS-232C Communication Setting.
• Mode : Serial • Data Bit : 8
• Port : Com1 • Parity : None
2. Setup menu Command.
Setup menu
Set AA, EE, 0F, CC, 55
Up AA, EE, 1E, CC, 55
Down AA, EE, 1D, CC, 55
Left AA, EE, 1B, CC, 55
Right AA, EE, 17, CC, 55
3. MD(Motion Detection) output Signal Level
0V
There is no motion
2.5±0.5sec
Notes
• You must turn the camera power off when you connect or remove the remote plug.
40
COLOR CCD CAMERA
• Bit/sec : 19200bps • Stop Bit : 1
Command Byte
5
5
5
5
5
+4.0V~+5.0V
There is motion
User's Manual
If you have trouble operating your camera, refer to the following table. If the
guidelines do not enable you to solve the problem, contact an authorized
technician.
Problem
Nothing appears on • Check that the power cord and line connection
the screen.
between the camera and monitor are fixed properly.
• Check that you have properly connected VIDEO
cable to the camera VIDEO output jack.
• Check that the DC/VIDEO selection switch on the
side of the camera is set to a proper position
according to the type of your auto iris lens.
• Are you using Auto Iris Lens with VIDEO type?
Adjust VR Level properly (refer to page 32)
• Is lens stained with dirt? Clean your lens with soft,
The image on the
clean cloth.
screen is dim.
• Set the monitor to proper condition.
• If the camera is exposed to too strong light, change
the camera position.
• Adjust the lens' focus properly.
The image on the
• Adjust the contrast feature of the monitor.
screen is dark.
• If you have an intermediate device, set the 75Ω / Hi-z
properly. (refer to page 19)
• Are you using the Auto Iris Lens? Adjust the level
on the lens properly.
The camera is not working
• Check that you have properly connected the camera
properly, and the surface
to an appropriate power source. (refer to page 20)
of the camera is hot.
COLOR CCD CAMERA

Troubleshooting

Solution
41
User's Manual