Connecting A Serial Device (Optional) - LevelOne FCS-1150 User Manual

Connecting a Serial Device (Optional)

The camera can be connected to a Pan-Tilt (PT) Scanner (Pan-Tilt Head) using the serial port
connector. This allows the zoom camera to do pan and tilt using the Pelco-D protocol. Most PT
scanners accept Pelco-D and Pelco-P protocol commands via RS-485 or RS-422 connection,
which are both supported by your camera.
Check the connection available on the PT scanner and connect it to your camera following the
procedures below.
1. Map the wires from the PT scanner to your camera using the supplied terminal block
according to one of the tables below.
Via RS-485 Connection
Terminal Block
Pin Number / Label
1
2
3
4
5
Via RS-422 Connection
Terminal Block
Pin Number / Label
1
2
3
4
5
NOTE: The pins of the PT Scanner may be labeled differently depending on the location or
country where the scanner is purchased. For example, some devices may have TX – pin
labeled as "A" or "485 -", etc. Refer to the scanner documentation or contact the
manufacturer to verify the corresponding pin labels and ensure proper wiring connection.
Hardware Manual
Camera Pin
TX + TX +
TX - TX -
GND
RX+
Rx-
Camera Pin
TX + TX +
TX - TX -
GND
RX+ RX +
Rx- RX -
16
Wire Mapping
PT Scanner Pin
TX +
TX -
GROUND PIN
-
-
Wire Mapping
PT Scanner Pin
RX +
RX -
GROUND PIN
TX +
TX -