Deleting A Still Image File; Deleting All Still Image Files; Recording A Motion Picture - Sharp LC-65G5X Operation Manual

Using memory card

Deleting a still image file

1
Repeat steps 1 to 4 in My Programme.
2
Press a/b to select "Edit", and then press
ENTER.
3
Press a/b to select "Delete File", and then
press ENTER.
4
Press a/b/c/d to select the file you want
to delete, and then press ENTER.
5
Press c/d to select "Yes", and then press
ENTER.
6
Repeat the operations in steps 4 and 5
above.
7
After deleting the images you no longer need,
press RETURN to return to MENU.
NOTE
• You cannot delete a protected file on the card.
• Do not turn off the power or take out a card when deleting
a file. The card may malfunction.

Deleting all still image files

1
Select "Delete All" instead of "Delete File" in
step 6 in Deleting a still image file.
Slide Show Setup
My Programme
Audio Select
Edit
2
Press c/d to select "Yes", and then press
ENTER.
NOTE
• You cannot delete a protected file on the card.
• Do not turn off the power or take out a card when deleting
a file. The card may malfunction.
40
Still Video
File 1 File 2 File 3
File 4 File 5 File 6
File 7 File 8 File 9
Protect
Delete File
Delete All

Recording a motion picture

Use this setting to record images you are currently
watching.
Record with the settings made in "Rec. Mode" and
"Pre-recording".
1
Press E REC to start recording.
• CARD indicator lights up red.
• Recording information displays in the lower
right corner of the screen.
2
Press E REC to stop recording.
NOTE
Broadcasting types or input signals not available for
recording:
1 COMPONENT input
2 Copy guarded signal
3 DVI-I input
To display the remaining record time.
Press DISPLAY while not recording.
• Remaining record time displays in the lower right corner
of the screen.
NOTE
• Do not press POWER on the Display while recording.
Recording cannot finish properly and may damage the
file.
• Recording stops if you press POWER on the remote
control while recording.
• When card has no capacity for recording, "Card is full"
displays and stops recording.
• You cannot change the channel or switch the input source
while recording.
Selecting Video mode
1
Press CARD and the card mode screen
displays.
2
Press c/d to select "Video", and then press
ENTER.
• When in CARD mode, press 0-9 or TV/VIDEO
to switch either TV or AV input mode.