Deleting A Still Image File; Deleting All Still Image Files; Recording A Motion Picture - Sharp Aquos LC-45GD1E Operation Manual

Using memory card

Deleting a still image file

1
Press CARD and the card mode screen
displays.
2
Press MENU and the MENU screen displays.
3
Press c/d to select "Card".
4
Press a/b to select "Still Setup", and then
press OK.
5
Press a/b to select "Edit", and then press
OK.
6
Press a/b to select "Delete File", and then
press OK.
7
Press a/b/c/d to select the file you want
to delete, and then press OK.
8
Press c/d to select "Yes", and then press
OK.
9
Repeat the operations in steps 7 and 8
above.
10
After deleting the images you no longer need,
press RETURN to return to MENU.
NOTE
• You cannot delete a protected file on the card.
• Do not turn off the power or take out a card when deleting
a file. The card may malfunction.

Deleting all still image files

1
Select "Delete All" instead of "Delete File" in
step 6 in Deleting a still image file.
2
Press c/d to select "Yes", and then press
OK.
NOTE
• You cannot delete a protected file on the card.
• Do not turn off the power or take out a card when deleting
a file. The card may malfunction.
56

Recording a motion picture

Use this setting to record images you are currently
watching.
Record with the settings made in "Rec. Mode" and
"Pre-recording".
1
Press E to start recording.
• CARD indicator lights up red.
• Recording information displays in the lower
right corner of the screen.
2
Press E to stop recording.
NOTE
Broadcasting types or input signals not available for
recording:
1 DTV broadcasting
2 COMPONENT input
3 RGB input
4 Copy guarded signal
5 DVI-I input
To display the remaining record time.
Press p while not recording.
• Remaining record time displays in the lower right corner
of the screen.
NOTE
• Do not press a on the display while recording. Recording
cannot finish properly and may damage the file.
• Recording stops if you press B on the remote control
while recording.
• When card has no capacity for recording, "Card is full"
displays and stops recording.
• You cannot change the channel or switch the input source
while recording.
Selecting Video mode
1
Press CARD and the card mode screen
displays.
2
Press c/d to select "Video", and then press
OK.
• When in CARD mode, press 0-9 or b to
switch either TV or AV input mode.