Installation; Installation Procedure; Supplied Accessories; Operating Conditions - Sony SRW-5000 Installation Manual

1-1. Installation Procedure

Installation procedure of this unit is shown on the follow-
ing flowchart.
Refer to each section about detail of each flow.
The operation manual is also required to do *-marked
flow.
Start
Determination of

1-3. Operating Conditions

installation place
1-4. Power Supply
1-5. Installation Space
Unpacking
n
When the unit is transported, it is required to
pack the unit into the specified new packing
materials.
Do not reuse the packing materials.
1-6. Rack Mounting
Rack mounting
*Connection
1-7. Matching Connectors and
1-8. Signal Inputs and Outputs
*Initial setup 1-9. Switch Settings on Connector
1-10. Switch Settings on Circuit
1-11. System Setting
1-12. Opening/Closing the Lower
1-13. Reference System
1-14. Settings when Editor is
*Operation check
n
If an error message appears on the time data
display area, refer to the operation manual.
(For more details, refer to the maintenance
manual volume 1.)
End
SRW-5000/5500
Section 1

Installation

Cables
Panel
Boards
Control Panel
Connected

1-2. Supplied Accessories

Operation manual
Japanese ......................................................................... 1
English ........................................................................... 1
Operation manual CD-ROM (PDF) .................................. 1
Installation manual
Japanese ......................................................................... 1
English ........................................................................... 1
1-3. Operating Conditions
c
Good air circulation is essential to prevent internal heat
build-up. Place the unit in location with sufficient air
circulation.
Do not block the ventilation holes of the cabinet and the
front and rear panels.
Operating temperature: 5 dC to 40 dC
Operating humidity: 25 % to 80 % (non-condensing)
_20 dC to 60 dC
Storage temperature:
Locations to avoid:
. Areas where the unit will be exposed to direct sunlight
of any other strong lights.
. Areas near heat sources.
. Dusty areas or areas subject to vibration.
. Areas with strong magnetic field.
. Areas with much electrical noise.
. Areas with much static electricity.
. Areas that is impossible to find a specified room for
installation. (Refer to "1-5. Installation Space".)
. Areas windtight.
Tilt allowance: Within 30d (Do not slant the front
and rear of the unit more than 30d.)
c
Fix the unit securely to avoid drop when the unit is operat-
ed at not-horizontal place.
1-1