Taking Out The Cassette In Tape Slacking - Sony SRW-5000 Installation Manual

Reattaching
When reattaching the board, install in the reverse order of
removal.
m
. After inserting the board, push in the two folded eject
levers simultaneously to firmly connect the plug-in
board to the connector on the motherboard.
. When reattaching the upper lid (rear) assembly, be sure
to insert the protrusions in the square holes on the
chassis, and then secure the lid.
. Tighten the fixing screws as following torque.
Tightening torque: 120 x 10
SRW-5000/5500
_2
N.m {12.2 kgf.cm}
1-16. Taking Out the Cassette in Tape
Slacking
When slacking the tape in this unit, follow the steps below
to take out the cassette tape.
m
. Turn off the power and unplug the power cord before
taking out the cassette tape.
. Being careful not to damage the tape, take out the
cassette tape with care.
1. Fully loosen the fixing screw.
2. Slide the knobs on upper lid (front) assembly each in
the inside. (Move the knobs to the outside to fix the
upper lid (front) assembly.)
3. Remove the upper lid (front) assembly in the arrow
direction.
Knob
Fixing screw
Upper lid (front) assembly
Knob
Removal
Installation
1-41