Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Clifford 980074 SERIES 11CX
Summary of Contents for Clifford 980074 SERIES 11CX
-
Page 3: Limited Consumer Warranty
Limited Consumer Warranty For a period of one calendar year from the date of purchase of this auto-security device, Directed Electronics, Inc. promises to the ORIGINAL PURCHASER to repair or replace (with a comparable reconditioned model), free of cost, any electronic control module which proves to be defective in workmanship or material under normal use, SO LONG AS THE SYSTEM WAS SOLD, INSTALLED, AND SERVICED BY A PROFESSIONAL AUTO INSTALLER, AND REMAINS IN THE CAR IN WHICH THE SYSTEM WAS ORIGINALLY... - Page 4 TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUD- ED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COM- MERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO THE EXCLU- SION OF ANY AND ALL WARRANTY OF MERCHANTABILITY AND/OR ANY AND ALL WAR- RANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD.
- Page 5 2004 Directed Electronics, Inc. ©...
-
Page 6: Table Of Contents
Table of Contents Limited Consumer Warranty What Is Included ..........3 Important Information . - Page 7 2004 Directed Electronics, Inc. ©...
-
Page 8: What Is Included
What is Included ■ A control module ■ Two 3-button remote transmitters ■ A high-powered siren ■ A fault-proof starter interrupt on-board the control module ■ An LED Blue system status indicator ■ A push-button Valet Important Information Congratulations on the purchase of your state-of-the-art vehicle security system. -
Page 9: Your Warranty
replacement, remove the rear cover of the remote with a small, flat-blade screwdriver. Your Warranty Your warranty card must be returned and the barcode serial num- ber must not be removed. If the warranty card is not returned, no warranty will be honored on your unit. It is also necessary to keep your proof of purchase, which reflects that the product was installed by an authorized dealer. -
Page 10: Transmitter Functions
Transmitter Functions This system is programmable, making it possible to assign any trans- mitter button to any specific receiver function. The remote initially comes programmed with Standard Configuration, but may also be customized by an authorized dealer. The buttons in all of the instruc- tions in this manual correspond to a Standard Configuration remote. -
Page 11: Using Your System
Using Your System The transmitter buttons indicated in this manual correspond to a standard configuration transmitter, unless otherwise specified. Arming You can arm the security system by pressing for one second. When the system arms, you will hear a short siren sound (chirp) and the parking lights (optional) will flash once. -
Page 12: Disarming
NOTE: If any protected entry point, such as a door, ignition is open, Passive Arming will not engage. Additionally, each time a sensor is trig- gered during the Passive Arming countdown, the countdown starts over. Arming your security system protects your vehicle to the following degrees: ■... -
Page 13: Disarming Without A Transmitter
Disarming Without a Transmitter If your transmitter is lost or damaged, you can manually disarm your vehicle security system. To disarm the system without a trans- mitter, you must have the vehicle's ignition key and know where the Valet switch is located. Be sure to check with your installer at the time of installation for the location of the Valet switch. -
Page 14: Remote-Controlled Silent Arm/Disarm
Remote-Controlled Silent Arm/Disarm Use remote-controlled silent arm/disarm to temporarily turn off the arm or disarm chirps by briefly pressing arming or disarming. The confirmation chirp(s) will then be elimi- nated for that one operation only. To permanently turn off the arm and disarm chirps, contact your installation dealer. -
Page 15: Remote-Controlled Valet
Remote-Controlled Valet You can also enter or exit Valet Mode by using the remote transmitter: 1. Open any vehicle door. 2. Press 3. Press 4. Press again. The LED system status indicator will light solidly if you have entered Valet Mode and will turn off if you have exited Valet Mode. Diagnostics The microprocessor at the heart of your system has the ability to constantly monitor all of the switches and sensors connected to it. -
Page 16: Disarming Diagnostics
ignores the input that was active when the system was armed, until that input ceases. Three seconds after that input ceases, the system will resume normal monitoring. For example, if your vehicle has an interior light exit delay and you arm the system before the light turns off, you may hear a Bypass Notification chirp. -
Page 17: Stealth Coding Technology
ZONE (Number of DESCRIPTION LED Flashes) CX22 only CX22 only Door switch trigger Ignition trigger NOTE: The LED does not report when the warn-away response has been activated; it only reports triggered sequences. Stealth Coding Technology The receiver and transmitter use mathematical formulas called algorithms to change their codes each time the transmitter is used. -
Page 18: High Frequency
High Frequency Your system transmits and receives at 434 MHz. This provides a cleaner spectrum with less interference and a more stable signal. Enjoy a phenomenal increase in range, even in areas with high radio interference. Programming Options Programming options control your system's normal, operational set-up. -
Page 19: Installation Options
Installation Options Installation options may require additional parts or labor. Please consult your dealer. Interior Light Illumination: The interior domelight can be con- figured to illuminate for 30 seconds after the alarm is disarmed. If the system is rearmed during that 30-second period, the interior light illumination will terminate until the alarm is disarmed again. - Page 20 Input: Any physical connection to the security system. An input can be provided through a sensor, pinswitch or by existing systems in the vehicle, such as ignition or courtesy lights. LED: A red light mounted inside the vehicle, at a location deter- mined by the installer.
- Page 21 2004 Directed Electronics, Inc. ©...
-
Page 22: Quick Reference Guide (Removable)
QUICK REFERENCE GUIDE To arm using your remote: ■ Press on your transmitter for one second. When the system arms, you will hear a short siren sound, or chirp, and see the parking lights (optional) flash once. If the vehicle's power door locks are controlled by the system, the doors will lock. - Page 23 The company behind this system is Directed Electronics, Inc. Since its inception, DEI ® has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, DEI is ISO 9001 registered.