Toshiba RAS-M10YKV-E Service Manual page 75

No. Part name
Fan motor 1) Perform work of item 1 of
2) Remove the flange nut fixing the fan motor and
3) Remove the propeller fan.
4) Disconnect the connector for fan motor from the
5) Remove the fixing screws (3 pcs.) holding by
Compressor 1) Perform work of item 1 of
2) Extract refrigerant gas.
3) Remove the partition board.
4) Remove the sound-insulation material.
5) Remove terminal cover of the compressor, and
6) Remove pipe connected to the compressor with
7) Remove the fixing screw of the bottom plate and
8) Remove the fixing screw of the bottom plate and
9) Pull upward the refrigeration cycle.
10) Remove nut fixing the compressor to the
Reactor 1) Perform work of item 1 of
2) Remove lead wires clung in holder on the
3) Remove screws fixing the reactor.
Procedure
the propeller.
• Flange nut is loosened by turning clockwise.
(To tighten the flange nut, turn counterclock-
wise.)
inverter.
hands so that the fan motor does not fall.
(ST1TØ4 x 10 2 pcs.)
disconnect lead wire of the compressor thermo.
and the compressor from the terminal.
a burner.
heat exchanger. (ST1TØ4 x 10 1 pc.)
valve clamping plate. (ST1TØ4 x 10 2 pcs.)
bottom plate.
partition board.
(ST1TØ4 x 10 2 pcs.)
and .
 
and , , , .
 

, and .
 
– 75 –
Remarks
Fan motor
Propeller fan
Flange nut
Partition
Valve
board
clamping
plate
Compressor
thermo.
Compressor
Reactor