Toshiba RAS-M10YKV-E Service Manual page 70

No. Part name
Horizontal grille 1) Perform the process
Note: 2) Remove the screw fixing the louver motor, and
The horizontal
grille can not be 3) Remove the shaft of the horizontal grille from the
removed without
removing the
louver motor.
Heat exchanger 1) Perform the process
2) Remove the pipe holder from the rear side of main
3) Unhook the hooks fixing the left side of the heat
Cross flow fan
1) Perform the process
2) Loosen the set screw of the cross flow fan.
3) Remove the screw fixing the shaft bearing base.
4) Lift slightly up the left side of the heat exchanger,
When assembling it, fix it with the set screw on the
position where the gap between the rear plate surface
and the left end surface of the cross flow fan is 6 ~ 7
mm.
Shaft bearing 1) Perform the process
2) Remove the shaft bearing from the shaft bearing base.
• If a part of the shaft bearing is protruded from the
Fan motor 1) Perform the process
2) Perform the process
3) Remove the left and right motor bands.
4) Remove the fan motor after pulling the cross flow fan
Procedure
.
remove the louver motor.
drain-pan.
.
unit by removing the screw.
exchanger and remove the screw fixing it, then
remove the right side of the end plate from the rib
fixing the main unit by sliding the heat exchanger
slightly to the right side.
.
and pull the shaft bearing base out left downwards.
above.
<Caution for assembling>
housing, assemble it after pushing its portion into the
correct position in the housing.
above.
-2) above.
out sliding it left and right.
– 70 –
Remarks
Louver motor
Horizontal grille Screw
Hooks
Pipe holder
Hooks fixing the
heat exchanger
Shaft bearing
base
Screw fixing the
heat exchanger
Hook
Screw
Shaft Shaft
bearing base bearing base
6~7mm
Mount the fan motor as
Ribs Ribs shown in figure below
when assembling.
Put the end of lead
wire at the portion
between two ribs.
Cross Cross
flow fan flow fan
Rear plate