Warning! Safety First - Viper 5301 Installation Manual

Warning! Safety first

The following safety warnings must be observed at all times:
• Due to the complexity of this system, installation of this product must only be
performed by an authorized Directed Electronics dealer.
• When properly installed, this system can start the vehicle via a command
signal from the remote control. Therefore, never operate the system in an
area that does not have adequate ventilation.
The following precautions are the sole responsibility of the user; however, autho-
rized Directed Electronics dealers should:
• Never use a test light or logic probe when installing this
unit. Always use a multimeter.
• Never operate the system in an enclosed or partially enclosed area without
ventilation (such as a garage).
• When parking in an enclosed or partially enclosed area or when having
the vehicle serviced, the remote start system must be disabled using the
installed toggle switch. It is the user's sole responsibility to properly handle
and keep out of reach from children all remote controls to assure that the
system does not unintentionally remote start the vehicle.
USER MUST INSTALL A CARBON MONOXIDE DETECTOR
IN OR ABOUT THE LIVING AREA ADJACENT TO THE VE-
HICLE. ALL DOORS LEADING FROM ADJACENT LIVING AR-
EAS TO THE ENCLOSED OR PARTIALLY ENCLOSED VEHICLE
STORAGE AREA MUST REMAIN CLOSED AT ALL TIMES.
Use of this product in a manner contrary to its intended mode of operation may
result in property damage, personal injury, or death. Except when performing
the Safety Check outlined in this installation guide, (1) Never remotely start the
vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the
keys in the ignition. The user will be responsible for having the neutral safety fea-
ture of the vehicle periodically checked, wherein the vehicle must not remotely
start while the car is in gear. This testing should be performed by an authorized
Directed Electronics dealer in accordance with the Safety Check outlined in
this product installation guide. If the vehicle starts in gear, cease remote start
operation immediately and consult with the user to fix the problem immediately.
© 2008 Directed Electronics. All rights reserved.
5