Chevrolet S10 Pickup 2003 Owner's Manual page 378

Hide thumbs Also See for S10 Pickup 2003:
Table of Contents

Advertisement

27,000 Miles (45 000 km)
Change engine oil and filter (or every 3 months,
whichever occurs first). An Emission Control Service.
Lubricate chassis components (or every 3 months,
whichever occurs first). (See footnote #.)
Check rear/front axle fluid level and add fluid as
needed. Check constant velocity joints and axle seals
for leaking. (See footnote **.)
30,000 Miles (50 000 km)
Change engine oil and filter (or every 3 months,
whichever occurs first). An Emission Control Service.
Lubricate chassis components (or every 3 months,
whichever occurs first). (See footnote #.)
Check rear/front axle fluid level and add fluid as
needed. Check constant velocity joints and axle seals
for leaking. (See footnote **.)
For Two-Wheel-Drive vehicles only: Clean and
repack the front wheel bearings (or at each
brake relining, whichever occurs first).
4.3L V6 Engine Only: Replace fuel filter. An Emission
Control Service. (See footnote †.)
Replace engine air cleaner filter. See Engine Air
Cleaner/Filter on page 5-19 for more information.
An Emission Control Service.
6-10
Change automatic transmission fluid and filter if the
vehicle is mainly driven under one or more of these
conditions:
− In heavy city traffic where the outside
temperature regularly reaches 90°F (32°C) or
higher.
− In hilly or mountainous terrain.
− When doing frequent trailer towing.
− Uses such as found in taxi, police or delivery
service.
If you do not use your vehicle under any of these
conditions, change the fluid and filter every 50,000 miles
(83 000 km).
Rotate tires. See Tire Inspection and Rotation on
page 5-64 for proper rotation pattern and additional
information. (See footnote +.)
33,000 Miles (55 000 km)
Change engine oil and filter (or every 3 months,
whichever occurs first). An Emission Control Service.
Lubricate chassis components (or every 3 months,
whichever occurs first). (See footnote #.)
Check rear/front axle fluid level and add fluid as
needed. Check constant velocity joints and axle seals
for leaking. (See footnote **.)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents