Maintenance Schedule; Engine Oil Additives; When To Change Engine Oil - Chevrolet S10 Pickup 2003 Owner's Manual

As in the chart shown previously, SAE 5W-30 is the
only viscosity grade recommended for your vehicle. You
should look for and use only oils which have the API
Starburst symbol and which are also identified as
SAE 5W-30. If you cannot find such SAE 5W-30 oils,
you can use an SAE 10W-30 oil which has the API
Starburst symbol, if it's going to be 0°F (−18°C)
or above. Do not use other viscosity grade oils, such as
SAE 10W-40 or SAE 20W-50 under any conditions.
Notice: Use only engine oil with the American
Petroleum Institute Certified For Gasoline Engines
starburst symbol. Failure to use the recommended
oil can result in engine damage not covered by
your warranty.
®
GM Goodwrench oil meets all the requirements for
your vehicle.
If you are in an area of extreme cold, where the
temperature falls below −20°F (−29°C), it is
recommended that you use either an SAE 5W-30
synthetic oil or an SAE 0W-30 oil. Both will provide
easier cold starting and better protection for your engine
at extremely low temperatures.
5-18

Engine Oil Additives

Don't add anything to your oil. The recommended oils
with the starburst symbol are all you will need for
good performance and engine protection.

When to Change Engine Oil

If any one of these is true for you, use the short trip/city

maintenance schedule:

•
Most trips are less than 5 miles (8 km). This is
particularly important when outside temperatures
are below freezing.
•
Most trips include extensive idling (such as frequent
driving in stop-and-go traffic).
•
You frequently tow a trailer or use a carrier on top
of your vehicle.
•
The vehicle is used for delivery service, police, taxi
or other commercial application.
Driving under these conditions causes engine oil to
break down sooner. If any one of these is true for your
vehicle, then you need to change your oil and filter
every 3,000 miles (5 000 km) or 3 months — whichever
occurs first.