Connecting The Network Cables; Table 2-4. Model Ga620 (1000Base-Sx) Cable Characteristics - NETGEAR GA 620 Reference Manual

GA620/620T.Manual.R2 6/12/00
3. Insert the card into the PCI expansion slot.
Note: To avoid damaging any components on the card, handle it by the edges,
using your thumbs to push it securely into the PCI slot. Do not use excessive
force, but make sure the card is fully inserted into the slot to prevent the
PC operating system from freezing at startup.
The connector dock in a 32-bit PCI slot is shorter than in a 64-bit PCI slot.
When installed in a 32-bit PCI slot, part of the connector edge remains
undocked.This situation is normal.
4. Fasten the card to the rear of the computer chassis by tightening the screw that
is on the PC.
5. Replace the PC cover and reconnect the power cord to the PC.

Connecting the Network Cables

The Model GA620 Gigabit Ethernet Card has one SC-type connector for attaching
the server or workstation to a Gigabit Ethernet fiber segment.The port is capable of
auto negotiating and supports full-duplex operation.
To connect a network cable:
1. Choose an appropriate cable, using the information listed in Table 2-4.

Table 2-4. Model GA620 (1000BASE-SX) Cable Characteristics

Multimode Fiber
Operating Range
*Shortwave laser optics (850 nm)
hardware installation
1:55 PM Page 20
62.5/125 Micron* 50/125 Micron*
2 to 260 meters 2 to 550 meters
(in compliance with IEEE 802.3z)
2-8