Connect the Network Cables
Using the UTP cable that is supplied, connect any port on the hub to the port on the network card.
Note: One of the ports on NETGEAR hubs is switchable between Normal (MDI-X)
and Uplink (MDI) with a Normal/Uplink push button. If you are using this switchable
port on a NETGEAR hub to connect to a PC or the network card, make sure the
Normal/Uplink push button is set to Normal.
PC with network
card installed
Hub
Category 5 10/100 Mbps UTP cables*
*Use the cables provided or any Category 5 UTP cable.
Maximum length = 100 meters (300 feet)
Model EA201 Network Card Installation Guide
Power adapter
PC with network
card installed
RJ-45
connector
Printer
(optional)
RJ-45
connector