Internal Loopback Test - NETGEAR GA 620 Reference Manual

GA620/620T.Manual.R2 6/12/00
4. Click on the Adapter tab.
Any previously installed driver is listed in the Network Adapters list.
5. Click on the network card you want to remove, and then click on Remove.
Repeat step 5 for each network card that you want to remove.
6. Click on Close.
7. Click on Yes when asked if you want to restart you computer.
Your computer restarts using the new configuration.
Install the network card in a new slot by following the instructions in "Installing
Your Gigabit Ethernet Card" on page 2-7, and then install a network driver by
following the instructions in "Installing the Driver" on page 3-1.

Internal Loopback Test

The Tech Support tab in the GA620 Driver Properties window displays information
about how to contact NETGEAR's Technical Support and access to the Windows NT-
based internal loopback diagnostic test for the card. Use the internal loopback test to
verify that the card firmware is configured and operating correctly.
To perform the internal diagnostic test on an card, follow the steps in this section.
1. Open your system Control Panel and double-click the Network icon.
windows nt driver software
1:55 PM Page 32
3-10