Using The Troubleshooting Checklist; Table 6-2. Model Ga620T (10/100/1000Base-T) Port Led Activity - NETGEAR GA 620 Reference Manual

GA620/620T.Manual.R2 6/12/00
2. Verify that the card status LEDs operate as described in the Table 6-2.

Table 6-2. Model GA620T (10/100/1000Base-T) Port LED Activity

LED
Data
10
100
1000
Note: If all four LEDs remain lit simultaneously, the card driver software is
either missing or improperly installed.
Using a Troubleshooting Checklist
If you need to test the network card further, check the following items:
• Inspect all cables and connections. Check the length and rating of the cable.
Make sure that the cable segment is compliant with the requirements shown in
Table 2-4 on page 2-8 or Table 2-5 on page 2-10.
• Connect the network card to a different network port and run the tests again. If
successful, the original network port may be defective or improperly configured.
1:55 PM Page 61
State Description
Blinking Brief bursts of data detected on the port.
On Streams of data detected on the port.
Off No data detected on the port.
On Good 10 Mbps Ethernet link
Off No 10 Mbps link; possible link at different speed, possible bad cable,
bad connector, or configuration mismatch.
On Good 100 Mbps Fast Ethernet link.
Off No 100 Mbps link; possible link at different speed, possible bad cable,
bad connector, or configuration mismatch.
On Good Gigabit Ethernet link.
Off No 1000 Mbps link; possible link at different speed, possible bad cable,
bad connector, or configuration mismatch.
troubleshooting 6-5