Skil 2354 Operating/Safety Instructions Manual page 19

SM 1619X05087 05-12_SM 1619X05087 12-09 5/24/12
When the indicator light turns "OFF" fast
charging is complete.
If the green charging indicator light turns red
during use, this indicates the battery needs to
be charged.
fter normal usage, the battery requires
approximately 3 to 5 hours charging time to
reach full capacity. The tool may be used even
though the light may still be on. The light may
require more than 3 hours to turn off depending
on temperature.
The purpose of the light is to indicate that the
battery is fast-charging. It does not indicate the
exact point of full charge. The light will turn off
in less than 3 hours if the battery was not
completely discharged.
When the battery is fully charged, unplug the
charger (unless you're charging another tool).
INSERTING BITS
Your tool is equipped with an magnetic bit
holder. Simply push the bit into the bit holder as
far as it will go (Fig. 3).
F STENING WITH SCREWS
The procedure shown in figure. 4 will enable
you to fasten materials together with your
Cordless Screwdriver without stripping,
splitting, or separating the material.
First, clamp the pieces together and drill the first
hole 2/3 the diameter of the screw. If the
19