Skil 2710 Original Instructions Manual
Hide thumbs
Also See for 2710:
- Original instructions manual (209 pages) ,
- Original instructions manual (209 pages)
Related Manuals for Skil 2710
Summary of Contents for Skil 2710
- Page 1 CORDLESS SCREWDRIVER 2710 (SD1*2710**) ORIGINAL INSTRUCTIONS www.skil.com SKIL BV - Rithmeesterpark 22 A1 - 4838GZ - Breda - NL 10/22 2610S01592 UK: Chervon Europe Ltd. - 34 Bridge Street- Reading - RG1 2LU...
- Page 2 2014/30/EU SD1*2710** 2011/65/EU EN 62841-1:2015 EN 62841-2-2:2014 EN 55014-1:2021 EN 55014-2:2021 EN 50581:2012 Skil BV Rithmeesterpark 22 A1 4838 GZ Breda The Netherlands Olaf Dijkgraaf Approval Manager SKIL BV - Rithmeesterpark 22 A1 - 4838GZ - Breda - NL 31.10.2022...
- Page 3 Chervon Europe Ltd., 34 Bridge Street, Reading, RG1 2LU, United Kingdom, as authorized representative (in terms of above regulations) acting on behalf of Skil BV, Rithmeesterpark 22 A1, 4838GZ Breda, The Netherlands James McCrory Technical Service Manager Place of issue: Reading...
- Page 4 2710 4V Max Volt 2610S00722 / 2610S00723 Micro-B Micro-B...
- Page 7 PHILLIPS POZIDRIV SLOTTED TORX ➞ ACCESSORIES WWW.SKIL.COM...
-
Page 8: Technical Data
(cordless) power tool. Cordless screwdriver 2710 1) WORK AREA SAFETY a) Keep work area clean and well INTRODUCTION lit. Cluttered or dark areas invite accidents. • This tool with left/right rotation is b) Do not operate power tools in... - Page 9 doing and use common sense will do the job better and safer at the rate for which it was designed. when operating a power tool. Do not use a power tool while you b) Do not use the power tool if the switch does not turn it on and are tired or under the influence of drugs, alcohol or medication.
- Page 10 CHARGING/BATTERIES 6) SERVICE • Only use SKIL charger 2610S00722 a) Have your power tool serviced by a (U.K. 2610S00723) with this tool qualified repair person using only • This charger identical replacement parts.
- Page 11 • SKIL can assure flawless functioning of the tool only when original limitations or a accessories are used BEFORE USE lack of experience • Always check that the supply voltage or knowledge is the same as the voltage indicated...
-
Page 12: Application Advice
- push bit to end position in bitholder testing procedures, repair should be carried out by an after-sales service ! do not use bits with a damaged centre for SKIL power tools shank - send the tool or charger • Automatic spindle-lock... -
Page 13: Noise / Vibration
ENVIRONMENT significantly increase the exposure level Only for EU countries - the times when the tool is switched • Do not dispose of electric tools, off or when it is running but accessories and packaging together not actually doing the job, may with household waste material significantly reduce the exposure - in observance of European Directive...