Configuring The Print Server; Configuring The Sbg1000 Print Server - Motorola SBG1000 User Manual

Overview Installation Troubleshooting Contact

Configuring the Print Server

The SBG1000 print server supports a printer connected to its printer port using Microsoft, UNIX (Linux), or Apple
printing. Configuring printing consists of:
•

Configuring the SBG1000 Print Server

•
Connecting the printer to the SBG1000 as shown in
•
Adding a printer to each PC following one of:
— "Adding a Printer in Windows 98 or Windows Me"
— "Adding a Printer in Windows 2000"
Configuring the SBG1000 Print Server
1
Start the SBG1000 Setup Program as described in
2
On the left frame, click Printer to display the Printer CONFIGURATION > basic page:
3
(Optional) For a printer that supports bi-directional communication, you can enable Extended Capabilities
Port (ECP) Mode, which can provide a performance benefit over a standard port.
4
Use the following pages to configure the print server for the necessary platform(s):
Windows Printer > CONFIGURATION — Microsoft smb Page
Macintosh Printer > CONFIGURATION — Apple Page
UNIX (Linux) Printer > CONFIGURATION — lpr Page
5
Power off the SBG1000.
6
Connect the printer to the printer port on the SBG1000
7
Power on the printer.
8
Power on the SBG1000. If printer configuration was successful, the printer icon displays on the SBG1000
front panel.
If the printer icon is not displayed, check the printer cable connection and power the printer and the SBG1000
off and on again. Verify that Enable printer is checked on the Printer CONFIGURATON > basic page.
Home Print
Configuration: Basic Gateway TCP/IP Wireless Print Server USB
on page 90
X
81
Exit
FAQ Specifications Glossary License
"Installation" on page 19
on page 84
"Starting the SBG1000 Setup Program"
(see page 82)
(see page 83)
(see page 84)
Rear Panel as shown in
SBG1000 Wireless Cable Modem Gateway User Guide
on page 32.
"Installation" on page 19.