Yaesu FTA-310 Operating Manual page 50

01 [ SQL ]
Function: Squelch Level Setting.
Available Values: 0 ~ 8
Default Setting: 6
Select a setting for this Menu item which just silences
the receiver when no signal is present. Use the lowest
setting which will keep the receiver quiet between in-
coming transmissions.
02 [ MCLR ]
Function: Memory Channel Clear ("MR" memory
only).
To clear a Memory channel:
 Select the Menu Item MCLR.
 Press down on the VOLUME knob, then rotate the
DIAL selector knob to recall the memory channel to
be erased.
 Press down on the VOLUME knob to clear the
Memory channel (the Memory channel number will
return to "001").
Important Notice: An "erased" channel cannot be re-
stored, and "CH-001" cannot be erased, as it is used for
"Priority Channel" operation.
48
( "s " ) m
m
enu et
03 [ RESM ]
Function: Scan-Resume Mode Setting.
Available Values: 5S/CAR
Default Setting: 5S
"5S" (5-Second Pause) mode: the scanner will halt
for five seconds only, after which scanning will resume
(whether or not the other station is still transmitting).
"CAR" (Carrier Drop) mode: the scanner will remain
halted for as long as there is a carrier present on the
channel; after the carrier drops at the end of the other
station's transmission, the scanning will resume.
04 [ SCNL ]
Function: Scan Lamp On/Off (while paused).
Available Values: on/oFF
Default Setting: on
If you set this function to "on," the lamp will be illumi-
nated whenever the scanner pauses. The lamp will go off
automatically when scanning resumes.
ode
FTA-310 O
perATing
M
AnuAl