Field Programming Mode - Yaesu FTA-310 Operating Manual

The FTA-310's Book Memories also allow the user to
store, label, and recall channel frequencies which you
may want to use frequently while the FTA-310 is in the

Field Programming mode.

Memory Storage into the Book Memory
 Press and hold the PTT switch and VOLUME knob
while turning the radio on, to activate the Field Pro-
gramming Mode. The "Fd" icon will appear in the
upper left-hand corner of the
LCD to confirm that you are
in the Field Programming
mode.
 Select the desired frequency to be stored in the
Book Memory.
 Press and hold in the [ MW ( SPL-W )] key for 2 sec-
onds. The display will indicate "- BOOK -" and a
channel number will blink on the LCD.
 Within five seconds of pressing the [ MW ( SPL-W )]
key, rotate the DIAL selector knob to select the de-
sired memory channel number for storage.
44
F p
Ield rogrammIng
 Now press and hold in the [ MW ( SPL-W )] key for
 To label a memory with an alpha/numeric name, the
 Select succeeding characters in the same manner,
 After entering the entire name (eight characters
 Repeat this procedure to store additional frequencies
 Turn the radio off, then turn the radio back on again
m
ode
2 seconds; you will now see a blinking "A" on the
LCD. To attach an alpha/numeric name (label) to
the memory, proceed to the next step; otherwise
press and hold in the [ MW ( SPL-W )] key for 2 sec-
onds to save the entry and exit.
next step is to use the DIAL selector knob to select
any of the 48 available characters (including letters,
numbers, and special symbols). When the desired
first character appears, press down on the VOLUME
knob momentarily to move on to the next character.
pressing down on the VOLUME knob momentarily
after each selection.
maximum), press the [ MW ( SPL-W )] key for 2 sec-
onds to save all data for the channel.
into the Book Memory section, as desired.
to begin normal operation.
FTA-310 O M
perATing AnuAl