Table of Contents
Advertisement
A
ADJUSTING BLADE
PARALLEL TO TABLE SLOT
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Lower the cutting arm. The saw blade (A) Fig. 22
should be parallel to the left edge (B) of the table opening.
2. If an adjustment is necessary, loosen three screws
(C) Fig. 22 and move the cutting arm until the blade is
parallel with the left edge (B) of the table opening and
centered in the slot. Then tighten the three screws (C).
ADJUSTING FENCE
90 DEGREES TO BLADE
If the fence (A) Fig. 23 is removed from the saw, re-
adjust it after replacement so that it is 90 degrees to the
blade as follows:
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Place one end of the square (B) Fig. 23 against the
fence (A) and the other end against the blade.
2. To adjust, loosen the four screws (C) Fig. 24, and
adjust fence 90 degrees to the blade. Tighten the four
screws (C).
ADJUSTING DOWNWARD
TRAVEL OF SAW BLADE
DISCONNECT MACHINE FROM POWER
SOURCE.
1. The downward travel of the saw blade should be
limited to prevent the saw blade from contacting any
metal surfaces of the machine. This adjustment is made
by loosening locknut (A) Fig. 25, and turning adjusting
screw (B) in or out.
2. Lower the blade as far as possible. Rotate the blade
by hand to make certain the teeth do not contact any
metal surfaces and adjust if necessary.
3. After the downward travel of the saw blade has been
adjusted, tighten locknut (A)
Fig. 21
C
A
C
13
B
Fig. 22
B
Fig. 23
C
Fig. 24
A
B
Fig. 25
A
Hide quick links:
Advertisement
Table of Contents
