Attaching Miter Saw Arm To Base; Bevel Pointer/Table Lock Handle; Degree Position - Delta ShopMaster MS250 Instruction Manual

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
ATTACHING MITER SAW
ARM TO BASE
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Align the bevel lock handle screw (A) Fig. 2, on the
miter saw arm with the bevel hub (B) on the base.
2. Thread the bevel lock handle screw (A) Fig. 2, into the
bevel hub (B) by turning the bevel handle knob (K) Fig. 2A
and tighten securely.
ATTACHING BEVEL
POINTER
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Loosen the bevel lock handle (A) Fig. 2A, and tilt the
miter saw arm to the 45 degree position as shown.
2. Align the hole in the bevel pointer (C) Fig, 2A, with the
hole (D) in the back of the base.
3. Insert the M5x.8x10mm pan head screw with washer
(B) through the hole in the bevel pointer (C) Fig. 2A, and
thread the screw into the hole (D) in the back of the base
and tighten securely. NOTE: TO ADJUST THE
POINTER SEE SECTION "ADJUSTING 90 AND 45
DEGREE BEVEL STOPS".
ATTACHING TABLE LOCK
HANDLE
Thread table lock handle (A) Fig. 3 into the threaded hole
(B) of the arm bracket.
ROTATING TABLE TO 90

DEGREE POSITION

1. Loosen table lock handle (A) Fig. 4 one or two turns
and depress index lever (B) to release 45 degree positive
stop.
ASSEMBLY
8
B
A
Fig. 2
D
C
B
Fig. 2A
B
A
Fig. 3
B
Fig. 4
K
K
A