Hunter T Owner's Manual And Installation Manual page 15

8 • Completing Your Installation With or Without a Light Fixture (continued)
Installing the Light Fixture
1. Remove the switch housing cap and plug button from the lower
switch housing.
2. Remove the dummy terminals from the two wires in the lower
switch housing.
3. Push the wires from the light kit through the hole in the center of
the lower switch housing.
Note: When threading the wires, push the thin plug connector
(male) through first, and then push the other plug connector
(female) through the hole.
4. Screw the threaded rod of the light fixture into the lower
switch housing.
5. Install the nut and washer from the end of the light fixture
inside the lower switch housing.
6. Connect the plug connectors between the two white wires.
7. Connect the plug connectors between the black wire and
black/white wire.
Male Dummy
Female Dummy
Terminal
Terminal
15
41861-01 • 03/05/2010 • Hunter Fan Company
Cap
Plug Button
Threaded Rod
Steps 3 – 5
Step 1
Lower Switch
Housing