Hunter T Owner's Manual And Installation Manual page 14

8 • Completing Your Installation With or Without a Light Fixture (continued)
Steps 8-6 – 8-7
Lower Switch
Housing
Plug
Connector
Detail
Housing
Assembly Screw
8-6. To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only fit
together one way. Make sure the connectors are properly
Plug
Connector
aligned before connecting them. Incorrect connection could
cause improper operation and damage to the product.
8-7. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower
switch housings. Attach the lower switch housing to the upper
switch housing with three #6-32 x 3/8" housing assembly
screws.
If you are not installing the light fixture, your installation is
complete. Otherwise, proceed with step 8-8.
8-8. The last installation step when installing the light fixture is to
install the glass bowl. See "Installing the Glass Bowl" on page 16
for instructions.
Note: In compliance with Canadian energy regulations, this
ceiling fan contains a device that restricts the light kit
to a maximum of 190 Watts. Exceeding that limit or the
marked limit on this product may result in fire hazard or
improper operation.the troubleshooting section
14
41861-01 • 03/05/2010 • Hunter Fan Company