Lubrication Points - Stanley 100TS Owner's Manual

To ensure proper lubrication of moving parts, GXi recommends that you lubricate the following components with a high-
quality, EP2 high-temperature-based grease or equivalent. Should the conditions of operation be more severe than
normal, the lubrication interval may need to be shortened. GTR/OPE grease is the recommended lubricant.
Lubrication Point Locations
Your STANLEY tow behind mower had fourteen (14)

lubrication points.

Lubricate after every 50 hours of usage
1. Front wheels (4 locations, 1 on each
wheel shaft and 1 on each wheel axle)
2. Rear wheels (2 locations, 1 each wheel
axle)
3. Spindles (4 locations). Note: The
lower spindle bearing is sealed
on the bottom and open on the
top. The upper spindle bearing is
sealed on both sides. Failure to
frequently replenish grease will
cause premature lower bearing
failure. Frequent application of grease to this bearing is
critical to achieving long spindle life in harsh duty
Rev: Mar2011
20
Lubrication Points
environments.
4. Wing belt tensioner (2
locations, 1 on each wing)
5. Blade linkage (1 location)
6. Clutch(1 location)
STANLEY Tow Behind Mower
100TS