Table of Contents
Advertisement
Lubrication Points
48ZS
To ensure proper lubrication of moving parts, GXi recommends that you lubricate the following components with a high-
quality, EP2 high-temperature-based
grease or equivalent. Should the conditions of operation be more severe than
normal, the lubrication interval may need to be shortened. GTR/OPE grease is the recommended lubricant.
Lubrication Point Locations
48-inch mowers have mowers have 5 lubrication points.
Lubricate after every 50 hours of usage
1.
Front wheels (2 locations, 1 on each
wheel shaft)
Note: The lower spindle bearing is sealed on the
bottom and open on the top. The upper spindle
bearing is sealed on both sides. Failure to frequently
replenish grease will cause premature lower
bearing failure. Frequent application of grease to
this bearing is critical to achieving long spindle life
in harsh duty environments.
3.
Mower deck clutch pulley pivot
2. Spindles (1 location on the48-inch
deck).
Changing Battery
When disconnecting the battery make sure to
disconnect the negative terminal first and the positive
last. When reconnecting, connect the positive first
and the negative last.
I
DANGER
I
DANGER: Battery electrolyte
has sulfuric acid
which can cause severe burns and is a deadly
poison. Never drink and always avoid contact by
wearing gloves and safety glasses when servicing
the battery.
Charging Battery
Always charge battery in an open well ventilated area,
away from sparks and flames. Unplug charger before con-
necting or disconnecting from battery and always wear pro-
tective clothing and use insulated tools.
I
WARNING
I
WARNING: Do not allow battery terminals
to
touch any metal parts of the mower when remov-
ing the battery.
Never allow metal tools to short
between the battery terminals and metal parts of
the mower as this may cause sparks. Sparks can
also cause the battery gasses to explode which
can result in injury/death.
Rev:
May2011
STANLEY 48" ZS
25
Advertisement
Table of Contents
