For Wheelchair Transportation - Invacare Ranger II Storm Series Ranger II Storm Series MWD/FWD Operator And Maintenance Manual

PROCEDURE 3
Height Adjustment
F
Bracket
R
O
N
Caplug
T Washer
R
I
G
G
I
N
G
S
Mounting
Screw
Caplug
Cap
Footboard Bracket
Height
Adjustment
Bracket
NOTE: Only MWD footboard bracket shown for clar-
ity. The footboard bracket on the FWD model adjusts
in the same manner.
FIGURE 11 - ADJUSTING THE
REMOVABLE FOOTBOARD HEIGHT
DETAIL "A"
Flat
Washer
Two (2) Large
Washers
Footboard
Support Tube
Bracket
DETAIL "B"
Flat
Washer
Mounting
Positions
Threaded
Arm
PREPARING REMOVABLE
FOOTBOARD FOR WHEELCHAIR
Nut
TRANSPORTATION (FIGURE 12)
Removing The Removable Footboard Plate
1. Depress the push pins on the two (2) support tubes
on the removable footboard plate.
2. While performing STEP 1, grasp the removable
footboard plate and pull it away from the two (2) sup-
port tubes on the removable footboard mounting
brackets.
Installing The Removable Footboard Plate
1. Align the two (2) support tubes on the removable
footboard plate with the two (2) support tubes on the
removable footboard mounting brackets.
2. Push the two (2) support tubes on the removable
footboard plate onto the two (2) support tubes on
the removable footboard mounting brackets, until
the push pins release into the adjustment holes.
Make sure the push pins are fully protruding through
the adjustment holes BEFORE using the wheelchair.
Otherwise, injury or damage can occur.
3. Make sure the push pins are completely released.
Pull Removable
Footboard Plate Away
Nut
Support Tube
Removable
Footboard
Mounting
Bracket
NOTE: Bottom view of wheelchair/footboard shown
for clarity.
FIGURE 12 - PREPARING REMOVABLE FOOTBOARD

FOR WHEELCHAIR TRANSPORTATION

26
FRONT RIGGINGS
WARNING
Removable
Footboard Plate
Adjustment
Hole
Support
Tube
Push
Pin