Replacing Heel Loops; Installing/Removing Elevating Legrests - Invacare Ranger II Storm Series Ranger II Storm Series MWD/FWD Operator And Maintenance Manual

PROCEDURE 3
P93M Model Footrests (FIGURE 3)
1. Loosen, but do not remove the lug bolt and locknut
F
that secure the lower footrest to the footrest support.
R
2. Reposition the lower footrest to the desired height.
O
3. Securely tighten the lug bolt and locknut that secure
N
the lower footrest to the footrest support.
T
4. Repeat STEPS 1-3 for the opposite side of the wheel-
R
chair footrest, if necessary.
I
G
G
I
N
G
S
Locknut
FIGURE 3 - ADJUSTING FOOTREST HEIGHT - P93M
MODEL FOOTRESTS
REPLACING HEEL LOOPS (FIGURE 4)
1. Note the position of the hex bolt, coved washers and
locknut for reinstallation.
2. Remove the hex bolt, coved washers and locknut
that secure the lower footrest to the footrest support.
3. Remove the lower footrest.
4. Remove the phillips bolt, spacer and locknut that se-
cure the existing heel loop to the lower footrest.
5. Slide the existing heel loop off the lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1-6 to reassemble.
NOTE: When securing the heel loop to the lower footrest,
tighten the phillips screw and locknut until spacer is secure.
Locknut
Cover Washers
Lower Footrest
FIGURE 4 - REPLACING HEEL LOOPS
INSTALLING/REMOVING
ELEVATING LEGRESTS (FIGURE 5)
NOTE: On RANGER II
Legrests MUST be elevated to install/remove from
the wheelchair.
Installing
1. Turn the legrest to the side (open footplate is perpen-
Lug Bolt
Footrest
2. Install the legrest hinge plates onto the hinge pins on
Support
3. Rotate legrest toward the inside of the wheelchair until
Lower
Footrest
NOTE: The footplate will be on the inside of the wheel-
chair when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. After seated in wheelchair, adjust footplate to correct
Removing
1. Push the legrest release handle toward the inside of
2. Lift up on the legrest and remove from the wheel-
3. Repeat STEPS 1-2 for the opposite side of the wheel-
Footrest Support
Hex Bolt
Phillips Bolt
Spacer
Heel Loop
Locknut
22
dicular to wheelchair) and position the mounting holes
in the legrest hinge plates with the hinge pins on the
wheelchair frame.
the wheelchair frame.
it locks in place.
height by loosening the nut and sliding the lower foot-
rest assembly up or down until desired height is
achieved.
the wheelchair (facing the front of the wheelchair) and
swing the legrest to the outside of the wheelchair.
chair.
chair.
Legrest Release Handle
Legrest
Wheelchair
Hinge
Frame
Plates
Hinge
Pins
FIGURE 5- INSTALLING/REMOVING ELEVATING
LEGRESTS
FRONT RIGGINGS
Models, the Elevating
JR
Lower
Footrest
Assem-
bly
Nut