Invacare Ranger II Storm Series Ranger II Storm Series MWD/FWD Operator And Maintenance Manual page 40

PROCEDURE 9
FWD Wheelchairs (FIGURE 2)
REMOVING FRONT SHROUD.
1. Unclip the retaining strap securing the front shroud
and battery box to the wheelchair.
2. Feed the retaining strap through the front shroud.
S
H
3. Remove the front shroud from the wheelchair.
R
O
INSTALLING FRONT SHROUD.
U
1. Feed the retaining strap through the front shroud as
D
shown in FIGURE 2.
S
2. Position the bottom of the front shroud between the
battery box and the battery tray.
3. Clip the retaining strap together.
4. Pull end of retaining strap to secure front battery box
and front shroud in place.
REMOVING REAR SHROUD.
1. Peform one (1) of the following:
A. For 16,18, and 20-inch wide chairs:
Unclip the retaining strap securing the rear
shroud and battery box to the wheelchair.
Feed the retaining strap through the rear
shroud.
Remove the rear shroud from the wheel-
chair.
B. For 14-inch wide chairs:
Lift up on rear shroud and remove from
wheelchair.
INSTALLING REAR SHROUD.
1. Peform one (1) of the following:
A. For 16,18, and 20-inch wide chairs:
Feed the retaining strap through the front
shroud as shown in FIGURE 2.
Clip the retaining strap together.
Press down on the rear shroud until the two
(2) clips secure the rear shroud to the two (2)
side shrouds.
Pull end of retaining strap to secure rear bat-
tery box and front shroud in place.
B. For 14-inch wide chairs:
Algin clips of rear shroud with tabs on side
shrouds.
Press down on rear shroud until the two
clips and dual lock fastener secure the rear
shroud in place.
40
SHROUDS