Adjusting Forks - Invacare Ranger II Storm Series Ranger II Storm Series MWD/FWD Operator And Maintenance Manual

Invacare ranger ii storm series owner's operator and maintenance manual
Table of Contents

Advertisement

WHEELS
Towards
Outside of
Wheelchair
Motor Locks ENGAGED
(Drive Position)
Motor Locks DISENGAGED
(Free Wheel Position)
FIGURE 3 - ENGAGING/DISENGAGING MOTORS
WITH MOTOR LOCKS
ADJUSTING FORKS (FIGURE 4)
1. Remove the dust cover from the caster headtube.
2. To properly tighten caster journal system and guard
against flutter, perform the following check:
A. Tip back the wheelchair to floor.
B. Pivot both forks and casters to top of their arc
simultaneously.
C. Let casters drop to bottom of arc (wheels should
swing once to one-side, then immediately rest in
a straight downward position).
D. Adjust locknuts according to freedom of caster
swing.
3. Test wheelchair for maneuverability.
4. Readjust locknuts if necessary, and repeat STEPS
1-3 until correct.
5. Snap dust cover into the caster headtube.
Dust Cover
Locknut
Nylon Washer
FIGURE 4 - ADJUSTING FORKS
37
PROCEDURE 8
Caster
Headtube
Fork
Caster
W
H
E
E
L
S

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents