Back-Up Lamps - Chevrolet Volt 2013 Owner's Manual

10-28 Vehicle Care
3. Remove the air cleaner
assembly by pulling up to
release the rear two retention
posts from the securing
grommets. Then pull it forward to
remove the remaining retention
post from the securing grommet.
4. Remove the cover from the back
of the headlamp assembly by
turning it counterclockwise.
5. Remove the bulb from the
headlamp assembly by turning it
counterclockwise.
6. Disconnect the bulb from the
wiring harness connector.
7. Install the new bulb in the
headlamp assembly by turning it
clockwise.
8. Reconnect the wiring harness
connector.
9. Install the cover on the back of
the headlamp assembly by
turning it clockwise.
10. Install the air cleaner assembly
by lowering the three retention
posts into the grommets.
11. Install the engine air cleaner/
filter assembly cover. See
Engine Air Cleaner/Filter on
page 10 12.

Back-Up Lamps

The back-up lamp is in the rear
fascia.
To replace a bulb:
1. Remove the three inboard
screws from the aero panel
located under the rear fascia.
2. Push up on the aero panel to
locate the bulb socket.
3. Turn the bulb socket
counterclockwise to remove it
from the bulb assembly.
4. Pull the bulb from the bulb
socket.
5. Push a new bulb straight into the
bulb socket.
6. Reinstall the bulb socket by
lining up the tabs in the lamp
assembly and turn it clockwise
to lock it into place.
7. Replace the three inboard
screws from the aero panel.