Using The Wall-Mounted Door Control; To Open The Door Manually - Chamberlain LiftMaster Security+ 1210EM FS2 Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

Using the Wall-Mounted
Door Control
THE LIGHTED DOOR CONTROL BUTTON
(MODEL 1210EM)
Press the button to open or close the
door. Press again to reverse the door
during the closing cycle or to stop the
door while it's opening.
THE MULTI-FUNCTION DOOR
CONTROL (MODEL 1220EM)
Press the push bar to open or close
the door. Press again to reverse the
door during the closing cycle or to
stop the door while it's opening.
Light feature
Press the Light button to turn the
opener light on or off. It will not control the opener
lights when the door is in motion. If you turn it on and
then activate the opener, the light will remain on for
4-1/2 minutes. Press again to turn it off sooner.
Lock feature
Designed to prevent operation of the door from
hand-held remote controls. However, the door will
open and close from the Door Control, the Outside
Keylock and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push bar light will flash as long as the
Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push bar light will stop flashing. The
Lock feature will also turn off whenever the "Learn"
button on the motor unit panel is activated.

To Open the Door Manually

To prevent possible SERIOUS INJURY or DEATH from a
falling garage door:
• If possible, use emergency release handle to disengage
trolley ONLY when garage door is CLOSED. Weak or
broken springs or unbalanced door could result in an
open door falling rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
Push
• NEVER use handle to pull door open or closed. If rope
Bar
knot becomes untied, you could fall.
Lock
Button
Light
Button
The door should be fully
closed if possible. Pull down
on the emergency release
handle and lift the door
manually. To reconnect the
door to the opener, press the
door control button.
The lockout feature prevents
the trolley from reconnecting
automatically, Pull the
emergency release handle
down and back (toward the
opener). The door can then
be raised and lowered
manually as often as
necessary. To disengage the
lockout feature, pull the
handle straight down. The
trolley will reconnect on the
next UP or DOWN operation.
33
Trolley
Release
Emergency
Arm
Release
Handle
(Pull Down)
MANUAL DISCONNECT
POSITION
Trolley
Release
Arm
Emergency
Release Handle
(Pull Down & Back
Towards Opener)
LOCKOUT POSITION

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Liftmaster security+ 1220em fs2

Table of Contents