Troubleshooting Guide - Venturer PLV3117i Owner's Manual

TROUblEShOOTING GUIdE

SYMPTOM
No power.
The remote does not
function.
DVD
No sound or only a
very low-level sound
is heard.
No picture
The picture is not clear
Severe hum or noise
is heard.
The disc does not play.
CAUSE (AND REMEDY)
• Make sure the AC power cord is connected.
• Turn on the unit.
• Remove any obstacles between the remote and the unit.
• Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
• Replace the batteries in the remote with new ones.
• Make sure that you've selected DVD mode.
• The system is in pause mode. Press the
play mode.
• Fast forward or fast reverse is performed. Press the
to normal play mode.
• Make sure the AUDIO / VIDEO output and AV IN input connections
are correct.
• The DTS DVD cannot be decoded to have speaker output.
• This unit is too hot. Power off the unit for 30 minutes to cool down.
• The region number of the disc doesn't match the region number of
this unit.
• Clean the disc.
• The disc is scratched.
• The plugs and jacks are dirty. Wipe them with a cloth slightly
moistened with alcohol.
• Clean the disc.
• There is no disc inside ("No Disc" appears on the screen).
• Insert the disc correctly with the playback side facing down.
• Clean the disc.
• A non-NTSC disc has been inserted. The unit and disc region number
are incompatible.
• Condensation may have formed inside the unit due to a sudden change
in temperature. Wait about an hour for it to clear and try again.
E - 32
button to return to normal
button to return